Thursday, August 9, 2012

Citrix 1Y0-A26 exam dumps

QUESTION 1
An administrator is setting up the XenServer hosts in an environment to boot from SAN. In which BIOS would the administrator go to enable XenServer to boot from SAN?

A. Host
B. Array controller
C. Network interface card
D. Primary host bus adapter

Answer: D
QUESTION 2
Scenario: An administrator notices a duplex mismatch on the network interface card (NIC) which is configured as the management interface. The administrator realizes that the switch was set to 100 full, but XenServer auto-configured the NIC to 100 half, autoneg=on. How can the administrator ensure the XenServer host does NOT auto-configure the NIC in the future?

A. Change the NIC properties in the xsconsole.
B. Use the xe pif-configure-ip command to disable auto-configuration.
C. Use the xe pif-param-set command to set other-config:ethtool-autoneg=off.
D. Assign a new NIC to the management interface within the XenCenter Network tab.

Answer: C

QUESTION 3
Scenario: To improve performance and increase security, a network team will be moving all XenServer hosts into a more secure, and high resiliency subnet. The administrator must now change the subnet mask on all XenServer hosts to match the new network: 172.16.0.0/16. Which command will the administrator need to execute on each host?
A. xe pif-reconfigure-ip uuid= mode=dhcp netmask=255.255.0.0
B. xe pif-reconfigure-ip uuid= mode=static netmask=255.255.0.0
C. xe pif-reconfigure-ip uuid= mode=dhcp netmask=172.16.0.0/16
D. xe pif-reconfigure-ip uuid= mode=static netmask=172.16.0.0/16
Answer: B

We all know that Citrix 1Y0-A26 exam dumps is a popular exam Citrix certification exam can be a very good market acceptance. Meanwhile, the 1Y0-A26 exam dumps is a relatively difficult test, because it includes a lot of problems, how to quickly grasp all the knowledge it has always been a difficult point.
1Y0-A26 on the market there are many resource materials, but the content too much, to complete all learning may take a long time.

No comments:

Post a Comment